The side of the camper where it sits next to the wheel well had some rotten wood, and was bulging out. (I forgot to take a before shot...)
Since there is no support other than the rotten wood from the access door to the rear of the camper, I put a piece of 3/8 inch plywood on the inside glued and screwed to the part that is not rotten. Here is a shot of it. I already painted it, but need to touch up where the screws are...
Once the inside piece was mounted I took off all the rotten wood.
I replaced the wood with 3/8 inch plywood.
Then I glued and screwed a piece of 1/4 inch plywood down the whole length. I still need to cut the hole for the access door in the 1/4 ply, but I am going to wait.
No comments:
Post a Comment