water tank OOPS!

UPDATE:

ok, took the time to search for the hole.

Found it, chiseled out plywood.  

I could feel the spot in the plastic where the hole is, but had a hard time seeing it, so Ken drilled it out for me to put the well nut in.  

tested it, no leaks : )

Going to leave the plywood hole, it is only ~ 1in x 1in big. 

This is on the underside of the camper and will be against the bed of the truck.

(The pic below is after tank was full for 24 hrs)

----------------------------------------------------------------------------------------

I messed up and put a screw into the bottom of the camper. 

As soon as I screwed it in, I realized it was too long of a screw.I removed the screw, and the camper started to pee my fresh water out the bottom.  : (

I was thinking I needed to take the bottom plywood off the camper to fix it.

Then about 2 years later I had an idea

cut a hole in the plywood with a hole saw, and

fix it with a well nut.  

Not sure if that is the proper term, but is what I have decided to call it.

There is a nut at the end of the rubber piece.  

Had to buy the bolt and washer separate.

Set me back a whole $1.07

Below is what happens when you tighten the bolt.

Ok, I waited too long to come up with this plan. 

 I put water in the tank, so I could find the hole, and it did not pee for me.  : ( 

Instead I just wicked out a crack on the bottom edge of the camper.

I looked all over the bottom of the camper and am at a loss as to where it is at. :  (

There are about a hundred screws in the bottom of the camper.  

Guess I will put it off for another day...  again